where to find the filter side of the aquaterm furnace image

WHERE TO FIND THE FILTER SIDE OF THE AQUATERM FURNACE IMAGE INSTALL

But they all do the same thing, and they all use a filter to capture dust, dirt, pet hair and other impurities from the air that circulates through your home whenever the furnace is running.

WHERE TO FIND THE FILTER SIDE OF THE AQUATERM FURNACE IMAGE INSTALL

Each type has its place in different types of homes and depending on where the builders chose to install it. There are also downflow furnaces, which push the heated air downward, and horizontal furnaces which push the air sideways. This heated air then travels through the ductwork until it comes into your rooms through the various vents or registers – either in the floors, walls or ceilings.Īt the same time that it’s blowing air out through the registers, the blower is also drawing “return air” (which is cooler now) back through several return registers, the return air duct, and then it passes through the filter to start the journey all over again as heated air. Assuming the furnace is of the upflow design, there is a blower beneath the burners which blows the heated air upward into the plenum, which is a large box to which the ductwork is connected. The scenario is like this: In the heating season, your furnace heats air inside its cabinet by means of burners – usually either natural or liquid propane gas. It is installed in a place in your furnace ductwork where all of the air that circulates through your home must pass through. It can have either fiberglass or a pleated paper-looking center. The furnace filter is usually a square or rectangular, thin cardboard box that is usually between 1 and 4 inches thick, with the 1 inch thickness being the most common for residential furnaces. This makes the whole idea of changing it regularly make sense.

It’s good to know what the air filter is and what it does. When you gently pull the door away from the furnace or air handler, the filters will be found in brackets on the inside of the door. So, the return air is sucked into the furnace or air handler through the front of the “door” on the furnace. Manufactured homes usually don’t have return ducts at all. The register will be held in place by screws or perhaps just two knobs that are easily turned to allow access to the filter. This will usually be in a hallway somewhere near the center of the building. With these systems, there will often be one large return air register where the filter is located inside the home. Heat pump systems: Many small homes and manufactured homes have an outdoor heat pump that does both heating and cooling, such as those made by Goodman, Carrier, Rheem and others. The filter will usually slide out sideways. Again, the filter will be to one side of the middle where the return air duct meets the furnace. Horizontal furnaces are often used in a crawlspace or an attic where there isn’t much headroom. On a downflow furnace, the filter will usually slide out sideways.

This is because the return air is coming down, and the filter is located before the air re-enters the furnace. On a downflow furnace, the filter will be higher up – near the top of the furnace. But it will be where it is easy to reach and remove. It may slide into a slot between the furnace and return duct from the side or from the top. On an upflow furnace, it will usually be at the bottom – very near the floor. Here are some different types of furnaces, and where the filter will probably be located: Find the return air duct and you’ll find the filter – right where the return plenum connects to the furnace.

Where to find the filter side of the aquaterm furnace image